Lab Exercise: Configuring RIP

This lab is to setup an IP addressing scheme using class B networks and configure the RIP dynamic routing protocol on routers.

e-Lab Activity: RIP

In this lab, the students will take a look at the router topology before starting the lab.

e-Lab Activity: Using Classless IP Routing

In this lab, the student will configure the router to use classless routing when forwarding packets.

e-Lab Activity: Verifying RIP Configuration

This lab is to use IOS show commands to verify the operation of a router running RIP.

Lab Exercise: Troubleshooting RIP

This lab is to set up an IP addressing scheme using class B networks.

e-Lab Activity: Troubleshooting RIP Update Issues

This lab is  to perform a basic configuration of the router Pretoria.

e-Lab Activity: Troubleshooting RIP

In this lab, the students will be troubleshooting the Routing Information Protocol on the Luanda and Lusaka routers.

Lab Exercise: Preventing Routing Updates Through an Interface

This lab is to prevent routing updates through an interface to regulate advertised routes.

e-Lab Activity: Preventing Routing Updates Through an Interface

In this lab, the students will learn to prevent routing updates through an interface to regulate advertised routes and observe the results.

Lab Exercise: Load Balancing Across Multiple Paths

This lab is to configure load balance across multiple paths.

e-Lab Activity: Load Balancing Across Multiple Paths

In this lab, the students will load balance across multiple paths and observe load balancing.

e-Lab Activity: Integrating Static Routes with RIP

In this lab, the students will enable RIP to propagate static routes.

Lab Exercise: Configuring IGRP

This lab is to setup an IP addressing scheme using class C networks

e-Lab Activity: Configuring IGRP

In this lab, the students will learn to configure IGRP.

Lab Exercise: Default Routing with RIP and IGRP

This lab is to configure a default route and use RIP to propagate this default information to other routers.

e-Lab Activity: Configuring Default Routing with RIP and IGRP

In this lab, the students will configure a default route and use RIP to propagate this default information to other routers.

e-Lab Activity: Verifying IGRP Configuration

In this lab, the students will use IOS show commands to verify the operation of a router running IGRP.

e-Lab Activity: IGRP

In this lab, the students will set up dynamic routing between networks using IGRP.

Lab Exercise: Unequal Cost Load Balancing with IGRP

This lab is to observe unequal-cost load balancing and tune IGRP networks by using advanced debug commands.